Просмотр корзины → Товар успешно добавлен в корзину.
Adafruit ATSAMD09 Breakout with seesaw
Adafruit ATSAMD09 Breakout with seesawAdafruit ATSAMD09 Breakout with seesawAdafruit ATSAMD09 Breakout with seesaw

Adafruit ATSAMD09 Breakout with seesaw

359 грн.

Код товара: 3657
Категория:

Описание товара

  • Adafruit seesaw is a near-universal converter framework which allows you to add and extend hardware support to any I2C-capable microcontroller or microcomputer. Instead of getting separate I2C GPIO expanders, ADCs, PWM drivers, etc, seesaw can be configured to give a wide range of capabilities.

    For example, our ATSAMD09 breakout with seesaw gives you

    • 3 x 12-bit ADC inputs
    • 3 x 8-bit PWM outputs
    • 7 x GPIO with selectable pullup or pulldown
    • 1 x NeoPixel output (up to 63 pixels)
    • 1 x EEPROM with 64 byte of NVM memory (handy for storing small access tokens or MAC addresses)
    • 1 x Interrupt output that can be triggered by any of the accessories
    • 2 x I2C address selection pins
    • 1 x Activity LED

    But you can reprogram and reconfigure the chip to have more or less of each peripheral — as long as it fits into the ATSAMD09D14’s firmware! For example, there’s also a UART converter but it isn’t included in the default firmware.

    The ATSAMD09 breakout is great for development of seesaw capabilities (we use it in-house for our design work) or you can use it as-is to give your Raspberry Pi or ESP8266 more hardware support! Each breakout comes with the assembled and tested board, as well as some header strips.

    Please note: The boards do not come with a bootloader. If you want to do development on seesaw (e.g. changing the configuration) you’ll need to pick up a J-Link and we recommend a SWD adapter breakout. At this time our project is for Atmel Studio but you could probably get it working with arm gcc and a Makefile. We don’t provide any support for custom builds of seesaw — we think this is cool and useful for the Maker community!

    For more details including the documentation on how to use seesaw, libraries for Arduino/CircuitPython/Raspberry Pi Python, schematics, and more check out the Adafruit seesaw guide


  • TECHNICAL DETAILS

    • Uses I2C address 0x49 — can be changed to 0x4A, 0x4B or 0x4C
    • Please note - there’s a bug in the current shipping seesaw firmware that can only support up to 63 NeoPixels

    Product Dimensions: 32.0mm x 12.0mm x 3.5mm / 1.3″ x 0.5″ x

Работа магазина приостановлена. Заказы не принимаются.