Просмотр корзины → Товар успешно добавлен в корзину.
MiFare Classic (13.56MHz RFID/NFC) Clear Tag - 1KB

MiFare Classic (13.56MHz RFID/NFC) Clear Tag — 1KB

167 грн.

Код товара: 361
Категория:

Описание товара

This is a blank MiFare Classic ‘laundry’ tag — often used for laundry or identification but also found in other systems where a small proximity card is desired. This one is clear! The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another — the ID number cannot be changed.

  • S50 chip specification:
  • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
  • Built in encryption engine with 48-bit key
  • 4 Byte unique identifier burned into the chip
  • 13.56 MHz frequency

Tag specification:
25.4mm diameter x 1mm / 1″ diameter x 0.03″

0.9 grams / 0.03 oz
Works about 2″ away from reader

Работа магазина приостановлена. Заказы не принимаются.