Просмотр корзины → Товар успешно добавлен в корзину.
Panel Mount 10K Dual Log Potentiometer - 10K Dual Log
Panel Mount 10K Dual Log Potentiometer - 10K Dual LogPanel Mount 10K Dual Log Potentiometer - 10K Dual LogPanel Mount 10K Dual Log Potentiometer - 10K Dual Log

Panel Mount 10K Dual Log Potentiometer — 10K Dual Log

145 грн.

Код товара: 3394
Категории: ,

Описание товара

  • This Panel Mount 10K Dual Log Potentiometer is a dual-ganged potentiometer that will satisfy all your stereo-signal needs. Instead of just one potentiometer, you actually get two separate pots, ‘ganged’ together. Turning the grippy shaft twists both standard logarithmic-taper 10Kohm potentiometers. It’s smooth and easy to turn, but not so loose that it will shift on its own. We also offer this potentiometer in a singular configuration.

    Potentiometers, or «pots» to electronics enthusiasts, are differentiated by how quickly their resistance changes. In linear pots, the amount of resistance changes in a direct pattern. If you turn or slide it halfway, its resistance will be halfway between its minimum and maximum settings. That’s ideal for controlling lights or a fan, but not necessarily for audio controls. Volume controls have to cater to the human ear, which isn’t linear. Instead, logarithmic pots like this one increase their resistance on a curve. At the halfway point volume will still be moderate, but it will increase sharply as you keep turning up the volume. This corresponds to how the human ear hears. Using a log pot therefore gives the effect that a setting of full volume on the control sounds twice as loud as a setting of half volume. A linear pot used as a volume control would give large apparent changes in loudness at low volume settings, with little apparent change over the rest of the control´s range.

    Unlike some of our other potentiometers, this one is not breadboard-friendly. The pins are about 0.2″ apart so it will fit into a breadboard, but the two rows are close together so you’d short the two halves. Thus, we suggest soldering wires to the pins as necessary, using these in a perf-board that doesn’t have the rows connected, or designing a custom PCB.

    Once you’re done prototyping, you can drill a hole into your project box and mount the potentiometer using the included washer and hex nut. We’ve got plenty of matching T18-splined knobs that you can pair up.

     

  • TECHNICAL DETAILS

    • 10K ohm potentiometer, log taper
    • 100,000 Cycle Life
    • 16mm Body
    • Rotational travel: 300°
    • Static Stop Strength: 90 oz-in
    • Rotational Torque: 0.5 to 1.25 oz-in

    Product Dimensions: 26.5mm x 25.0mm x 17.0mm / 1.0″ x 1.0″ x 0.7″

    Product Weight: 7.5g / 0.3oz

Работа магазина приостановлена. Заказы не принимаются.