STEMMA Wired Potentiometer Breakout Board - 10K ohm Linear
STEMMA Wired Potentiometer Breakout Board - 10K ohm LinearSTEMMA Wired Potentiometer Breakout Board - 10K ohm LinearSTEMMA Wired Potentiometer Breakout Board - 10K ohm Linear

STEMMA Wired Potentiometer Breakout Board — 10K ohm Linear

297 грн.

Код товара: 4493
Категории: ,

Описание товара

  • For the easiest way possible to measure twists, turn to this STEMMA potentiometer breakout (ha!). This plug-n-play pot comes with a JST-PH 2mm connector and a matching  JST PH 3-Pin to Male Header Cables — 200mm, so wiring up is a cinch. Simply plug the cable in, then use the black wire to connect to your ground, white wire to the input/signal pin and the red wire to your power pin. The power pin voltage should match the voltage max of your analog input. So, if you’re using a 5V Arduino or compatible, connect red to 5V. If you’re using a 3V Feather board, tie red to 3V.If you want to connect to something with alligator clips use our STEMMA to Gator cable. To connect to something with a STEMMA 3-pin connector already, use this cable. 

    TECHNICAL DETAILS
    • PCB Dimensions: 28mm x 21mm
    • Potentiometer (L x W x H): 11.8mm x 10mm x 20mm

Работа магазина приостановлена. Заказы не принимаются.