Просмотр корзины → Товар успешно добавлен в корзину.
987_LRG
987back_LRG987insitu_LRG (1)

Stereo 3.7W Class D Audio Amplifier — MAX98306

514 грн.

Код товара: 987
Категория:

Описание товара

This incredibly small stereo amplifier is surprisingly powerful — able to deliver 2 x 3.7W channels into 3 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.7V-5.5VDC. Since the amp is a class D, its incredibly efficient (over 90% efficient when driving an 8Ω speaker at over a Watt) — making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell it got hot. This board is a welcome upgrade to basic «LM386″ amps!The inputs of the amplifier go through 1.0uF capacitors, so they are fully ‘differential’ — if you don’t have differential outputs, simply tie the R- and L- to ground. The outputs are «Bridge Tied» — that means they connect directly to the outputs, no connection to ground. The output is a 360KHz square wave PWM that is then ‘averaged out’ by the speaker coil — the high frequencies are not heard. All the above means that you can’t connect the output into another amplifier, it should drive the speakers directly.Comes with a fully assembled and tested breakout board with 1.0uF input capacitors. We also include header to plug it into a breadboard, 3.5mm screw-terminal blocks so you can easily attach/detach your speakers, and a 2×4 header + jumper to change the amplifier gain on the fly. You will be ready to rock in 15 minutes! Speakers are not included, use any 3ohm or greater impedance speakers.

  • Output Power: 3.7W at 3Ω, 10% THD, 1.7W at 8Ω, 10% THD, with 5V Supply
  • Passes EMI limit unfiltered with up to 12 inches (30 cm) of speaker cable
  • High 83dB PSRR at 217Hz
  • Spread-Spectrum Modulation and Active Emissions Limiting
  • Five pin-selectable gains: 6dB, 9dB, 12dB, 15dB and 18dB. Select with a jumper or by setting the G and G’ breakout pins (see schematic for breakout board showing gain pin settings for details)
  • Excellent click-and-pop suppression
  • Thermal and short-circuit/over-current protection
  • Low current draw: 2mA quiescent and 10uA in shutdown mode

Dimensions (without 0.1″ header): 

  • Length:28.25mm/1.11in
  • Width:24.15mm/0.95in
  • Height:3.03mm/0.12in
  • Weight:2.33g

Отзывы

Пока нет отзывов, хотели бы вы добавить свой отзыв?

Добавьте первый отзыв “Stereo 3.7W Class D Audio Amplifier - MAX98306”

*

Работа магазина приостановлена. Заказы не принимаются.